1989-Mitsu-Factory Manual · Передняя подвеска · страница 35 из 66 · Открыть оригинал PDF ↗
DISASSEMBLY AND REASSEMBLY
NotpE-
SERVICE POINTS OF DISASSEMBLY
3. REMOVAL OF NEEDLE BEARING
b!OPWA
(1) Remove the oil seal and take out the spacer.
(2) Drive out the needle bearing by tapping needles
uniformly.
Caution
Once removed, the needle bearing must not be
reused.
NozPGABa
SERVICE POINTS OF REASSEMBLY
3. INSTALLATION OF NEEDLE BEARING
(1) Apply the multipurpose grease to the roller surface of
the new needle bearing.
(2) Press-fit the needle bearing by using the special tools,
until it is flush with the knuckle end face.
Caution
Use care to prevent driving the needle bearing too
far in.
Оригинальная страница руководства
