1989-Mitsu-Factory Manual · Передняя подвеска · страница 58 из 66 · Открыть оригинал PDF ↗
18. REMOVAL OF DRIVE PINION ASSEMBLY
(I) Make mating marks on the drive pinion and companion
flange.
Caution
The mating mark made on the companion flange
must not be on the coupling surface of the flange
yoke and the front propeller shaft.
12) Drive out the drive pinion together with the drive pinion
spacer and drive pinion shims.
19. REMOVAL OF DRIVE PINION FRONT BEARING INNER RACE
MB99033901 Pull out the drive pinion front bearing inner race by using
the special tools.
27. REMOVAL OF DRIVE PINION REAR BEARING OUTER
RACE /28. DRIVE PINION FRONT BEARING OUTER
RACE
(1) Drive out the drive pinion rear bearing outer race from
the gear carrier by using the brass rod.
(2) Drive out the front bearing outer race in the same
manner.
Проверка
l Check the companion flange for wear or damage.
e Check the oil seal for wear or deterioration.
l Check the bearings for wear or discoloration.
l Check the gear carrier for cracks.
l Check the drive pinion and ring gear for wear or cracks.
l Check the side gears, pinion gears and pinion shaft for
wear or damage.
e Check the side gear spline for wear or damage.
Оригинальная страница руководства
