1989-Mitsu-Factory Manual · Передняя подвеска · страница 31 из 66 · Открыть оригинал PDF ↗
SERVICE POINTS OF REMOVAL
3. REMOVAL OF TORSION BAR
Refer to P.2-36:
5. DISCONNECTION OF LOWER BALL JOINT AND
KNUCKLE
(1) Loosen the nut tightening the lower ball joint to the
knuckle.
(2) Using a special tool. disconnect the lower ball joint
from the knuckle.
Caution
1. Use cord to bind the special tool closely so it won’t
become separated.
2. The nut should be loosened only, not removed.
8. REMOVAL OF SHOCK ABSORBER MOUNTING BOLTS
Remove the shock absorber lower part and compress the
shock absorber.
Проверка
NOZNcApr
Check the lower arm for cracks or deformation.
l Check the anchor arm assembly for wear or damage.
l Check the lower ball joint dust cover for cracks or
deterioration.
LOWER BALL JOINT END PLAY CHECK
Check the lower ball joint end play by following the steps
below.
I. Measure the lower ball joint end play with a dial indicator.
Limit : 0.5 mm (-020 in.)
2. If the lower ball joint end play exceeds the limit, replace
the lower ball joint.
REPLACEMENT OF LOWER ARM BUSHING N02ND~
1. Using a special tool, remove the bushing A from the
bracket.
NOTE
When removing the left hand bushing A. detach the
differential carrier. (Refer to P.2-53.)
Оригинальная страница руководства
