1989-Mitsu-Factory Manual · Передняя подвеска · страница 50 из 66 · Открыть оригинал PDF ↗
FRONT SUSPENSION - Inner Shaft
SERVICE POINTS OF DISASSEMBLY
lWZRFA6
2. REMOVAL OF BEARING
(1) Bend the outside periphery of dust cover inward with a
hammer.
.-
(2) After the special tool has been installed as shown,
tighten the nut of the special tool until the portion “A”
of the special tool touches the bearing outer race.
..-
(3) Press out the inner shaft from the bearing.
Caution
Do not allow the inner shaft to drop.
SERVICE POINTS OF REASSEMBLY N-a
5. INSTALLATION OF DUST SEAL
(I) Press-fit the new dust seal into the housing tube by
using the special tools, until it is flush with the housing
tube end face.
(2) Apply the multipurpose grease to the dust seal lip.
3. INSTALLATION OF DUST COVER
Using a steel pipe, force a new dust cover onto the inner _
shaft.
Оригинальная страница руководства
