1989-Mitsu-Factory Manual · Передняя подвеска · страница 55 из 66 · Открыть оригинал PDF ↗
DIFFERENTIAL GEAR BACKLASH CHECK
Check the differential gear backlash by following the steps
below.
(1) While locking the side gear with the wedge, measure the
differential gear backlash with a dial indicator on the
pinion gear.
NOTE
The measurement should be made for both pinion gears
individually.
Standard value : O-6.076 mm (O-.0030 in.)
Limit : 0.2 mm (.008 in.)
(2) If the backlash exceeds the limit, adjust by using the side
gear thrust spacers.
FINAL DRIVE GEAR TOOTH CONTACT CHECK
Refer to GROUP 3 - Differential Carrier (Inspection Before
Disassembly).
SERVICE POINTS OF INSTALLATION
NOZVDAB
4. INSTALLATION OF INNER SHAFT
Drive the inner shaft into the front differential carrier by
using the special tools.
Caution
Be careful not to damage the lip of the dust seal and oil
seal.
2. INSTALLATION OF DRIVE SHAFT
Refer to P.2-40.
Оригинальная страница руководства
