1989-Mitsu-Factory Manual · Передняя подвеска · страница 41 из 66 · Открыть оригинал PDF ↗
SERVICE POINTS OF REMOVAL
NOZOBACI
2. REMOVAL OF HUB COVER
Refer to P.2-17.
3. REMOVAL OF SNAP RING
Refer to P.2-17.
c
5. REMOVAL OF FRONT BRAKE ASSEMBLY
Refer to P.2-17.
7. DISCONNECTION OF TIE ROD ASSEMBLY AND
KNUCKLE
Refer to P.2-34.
9. DISCONNECTION OF LOWER BALL JOINT AND
KNUCKLE / 11. UPPER BALL JOINT AND KNUCKLE
Refer to P.2-34.
13. REMOVAL OF LEFT DRIVE SHAFT
Pull the drive shaft out from the differential carrier.
Caution
When pulling the drive shaft out from the differential
carrier, be careful that the spline part of the drive shaft
does not damage the oil seal.
Проверка
Nomcm
l Check the boot for damage or deterioration.
l Check the ball joint for operating condition and excessive
looseness.
l Check the splines for wear or damage.
SERVICE POINTS OF INSTALLATION
la3mDAM
13. INSTALLATION OF LEFT DRIVE SHAFT
Drive the drive shaft into the front differential carrier with a
plastic hammer.
Caution
Be careful not to damage the lip of the oil seal. Replace
the circlip which is attached to the D.O.J. side spline
part with a new one.
l ADJUSTMENT OF DRIVE SHAFT END PLAY
Refer to P.2-20.
Оригинальная страница руководства
