1989-Mitsu-Factory Manual · Передняя подвеска · страница 65 из 66 · Открыть оригинал PDF ↗
(6) Align the mating marks on the gear carrier and the
bearing cap, and then tighten the bearing cap.
(7) With the drive pinion locked in place, measure the final
drive gear backlash with a dial indicator on the drive
gear.
NOTE
Measure at four points or more on the circumference
of the drive gear.
Standardvalue : 0.11-0.16 mm (.0043-.0063 in.)
(8) Change the side bearing adjusting spacers as illus-
trated, and then adjust the final drive gear backlash
between the drive gear and the drive pinion.
NOTE
When increasing the number of side bearing adjusting
spacers, use the same number for each, and as few as
possible.
(9) Check the drive gear and drive pinion for tooth contact.
If poor contact is evident, make adjustment.
[Refer to GROUP 3 - Differential Carrier (Inspection
Before Disassembly)]
(lO)Measure the drive gear runout at the shoulder on the
reverse side of the drive gear.
Limit : 0.05 mm (.0020 in.)
(ll)lf the drive gear runout exceeds the limit, reinstall by
changing the phase of the drive gear and differential
case, and remeasure.
31. APPLICATION OF SEALANT TO DIFFERENTIAL COVER
Оригинальная страница руководства
