1989-Mitsu-Factory Manual · Передняя подвеска · страница 64 из 66 · Открыть оригинал PDF ↗
26. INSTALLATION OF SIDE BEARING INNER RACES
Press-fit the side bearing inner races to the differential
case by using the special tool.
l ADJUSTMENT OF FINAL DRIVE GEAR BACKLASH
(I) Install the side bearing adjusting spacers, which are
tinner than those remwed, to the side bearing outer
races, and then mount the differential case assembly
into the gear carrier.
NOTE
Select side bearing adjusting spacers with the same
thickness for both thedrive pinion side and the drive
gear side.
(2) Push the differential case assembly to one side, and
measure the clearance between the gear carrier and
the side bearing adjusting spacer with a feeler gauge.
(3) Measure the thickness-of the side bearing adjusting
spacers on one side, select two pairs of spacers which
correspond to that thickness plus one half of the
clearance plus 0.05 mm (.002 in.), and then install one
pair each to the drive pinion side and the drive gear
side.
(4) install the side bearing-adjusting spacers and differen-
tial case assembly, as shown in the illustration, to the
gear carrier.
(5) Tap the side bearing adjusting spacers with the brass
bar to fit them to the side bearing outer race.
Оригинальная страница руководства
