1989-Mitsu-Factory Manual · Передняя подвеска · страница 23 из 66 · Открыть оригинал PDF ↗
SERVICE POINTS OF DISASSEMBLY
NO?JEA!J
4. REMOVAL OF HOUSING C RING
NOTE
The ring is easily removable by pushing the brake (B) in
and using a small-end screwdriver, etc.
9. REMOVAL OF RETAINER (B) C RING
Using a special tool, lightly push the drive gear in and
remove the retainer (B) C ring.
NOTE
Since the return spring relaxes approx. 40 mm (1.57 in.),
the stroke of the press should be set to more than 40 mm
(1.57 in.)
Caution
1. Place a protective cover not to damage the cover
attaching surface of the housing before setting on
the press table.
2. Make sure that the pressing force does not exceed
200 N (44.1 Ibs.).
10. REMOVAL OF DRIVE GEAR ASSEMBLY/l 1. SLIDE GEAR ASSEMBLY/lZ. RETURN SPRING
Slowly reduce the pressure of the press until the return
spring fully relaxes.
Caution
When the pressure of the press is removed, make sure
that the retainer (A) is not caught by the retainer (B).
18. REMOVAL OF SLIDE GEAR C RING
Push the cam in and remove the slide gear C ring with the
spring compressed.
Проверка
l Check the drive gear and slide gear splines for damage.
l Check the cam portion of retainer (A) for wear and
damage.
l Check the cam for wear and damage.
l Check the slide gear and housing tooth surfaces for
damage.
l Check the retainer B and housing contact surfaces for
wear and damage.
Оригинальная страница руководства
