1989-Mitsu-Factory Manual · Передняя подвеска · страница 34 из 66 · Открыть оригинал PDF ↗
SERVICE POINTS OF REMOVAL No2mA.i
1. REMOVAL OF FRONT AXLE HUB AND FREE-WHEELING
HUB
Refer to P.2-17.
4. DISCONNECTION OF TIE ROD ASSEMBLY AND
KNUCKLE
Disconnect the tie rod from the knuckle by using the
special tool.
Caution
1. Use cord to bind the special tool closely so it won’t
become separated.
2. The nut should be loosened only, not removed.
6. DISCONNECTION OF LOWER BALL JOINT AND
KNUCKLE/ 8. UPPER BALL .fOiNT AND KNUCKLE
Using the special tool, remove the lower ball joint and
upper ball joint.
Caution
1. Support the lower arm with a jack when removing
the knuckle from the lower ball joint or the upper
ball joint.
2. After the knuckle has been removed, lower the jack
slowly. ~~
3. Use cord to bind the special tool closely so it won’t
become separated.
4. The nut should be loosened only, not removed.
INSPECTION ww
l Check the needle bearing for wear or damage.
o Check the knuckle for cracks or bends.
e Check the knuckle spindle for wear or pounding.
SERVICE POINTS OF INSTALLATION
NOZPDAB
1. INSTALLAnON OF FRONT AXLE HUB AND FREE-
WHEELING HUB
Refer to P.2-17.
Оригинальная страница руководства
