1987-Montero · Front susp a · страница 22 из 83 · Открыть оригинал PDF ↗
L,imit : 100 Ncm (8.7 in. Ibs.)
[Spring scale reading]
14 N (3.1 Ibs.)
0 If the free-wheeling hub turning resistance exceeds the
limit, disassemble and reassemble the free-wheeling
hub again.
. ADJUSTMENT OF DRIVE SHAFT END PLAY
After the installation of shim and snap ring, check the drive
shaft end play by the following procedure.
0 Rotate the drive shaft forward, and backward and then
set the drive shaft to the position (the position where
end play is maximum) mid-way between where the
rotation feels “heavy” for each (where there is a
stopping feeling).
Set the dial gauge as shown in the figure; then move
the drive shaft in the axial direction and measure the
play.
!Standard value : 0.2-0.5 mm (.OO&.020 in.)
0 If the play isout of standard value, adjust by adding or
removing shims.
f
Оригинальная страница руководства
