1987-Montero · Front susp a · страница 80 из 83 · Открыть оригинал PDF ↗
(5) Measure the drive pinion rotation torque (with oil seal)
to verify that the drive pinion preload complies with the
standard value.
!standard value : 0.647 Nm (5.2-6.1 in.lbs.)
(6) If the measured value is not within the standard value
range, check for faulty installation of the oil seal or
faulty tightening of the self-locking nut.
l ADJUSTMENT OF DIFFERENTIAL GEAR BACKLASH
(1) Assemble the side gears, side gear thrust spacers,
pinion gears, and pinion washers into the differential
case.
(2) Temporarily install the pinion shaft.
NOTE
Do not drive in the lock pin yet.
(3) Insert a wedge between the side gear and the pinion
shaft to lock the side gear.
(4) Measure the differential gear backlash with a dial
indicator on the pinion gear.
Standard value : O-0.076 mm (O-.0030 in.)
Limit : 0.2 mm (.008 in.)
(5) If the differential gear backlash exceeds the limit,
adjust the backlash by installing thicker side gear thrust
spacers.
(6) Measure the differential gear backlash once again, and
confirm that it is within the limit.
If adjustment is not possible, replace the side gears
and pinion gears as a set,
; ,I
23. INSTALLATION OF LOCK PIN
(1) Align the pinion shaft lock pin hole with the differential
case lock pin hole, and drive in the lock pin.
(2) Stake the lock pin with a punch at two points.
Оригинальная страница руководства
