1987-Montero · Front susp a · страница 79 из 83 · Открыть оригинал PDF ↗
(3) Measure the drive pinion rotation torque (without the
oil seal).
Standard value : 0.4-0.5 Nm (3.5-4.3 in.lbs.)
(4) If the drive pinion rotation torque is not within the
range of the standard value, adjust the preload by
replacing the drive pinion rear shim(s) or the drive
pinion spacer.
NOTE
When selecting the drive pinion rear shims, if the
number of shims is large, reduce the number of shims
to a minimum by selecting the drive pinion spacers.
(5) Remove the companion flange and drive pinion once
again.
T”
?
?
With Oil Seal
(1) After setting the drive pinion rear bearing inner race, drive
the oil seal into the gear carrier front lip by using the
special tool.
(2) Apply the specified grease to the oil seal lip.
Specified grease : Multipurpose grease SAE 5310, NLGI
No. 2
(3) Apply a thin coat of specified grease to the companion , ”
flange contacting surface of the washer before installing $
drive pinion assembly. 1
Specified grease : Multipurpose grease SAE 5310, NLGI :-
No. 2
li.,. : .
i;?.
(4) Install the drive pinion assembly and companion flange
with mating marks properly aligned, and tighten the
companion flange self-locking nut to the specified
torque by using the special tools.
Оригинальная страница руководства
