1987-Montero · Front susp a · страница 31 из 83 · Открыть оригинал PDF ↗
SERVICE POINTS OF INSTALLATION
NOZGDBB
Q ADJUSTMENT OF WHEEL BEARING PRELOAD
(1) Using the special tool, tighten the lock nut by the
following procedure.
Tighten to 130-200 Nm (94-145 ft.lbs.)
w
Loosen to 0 Nm (0 ft.lbs.)
Retighten to 25 Nm (18ft.lbs.) and then loosen 30”40
(2) Loosen the lock nut approximately 30 to 40 degrees to
adjust the front hub’s turning resistance and play in the
axial direction so that they agree with the standard
values.
Standard value : 30-130 Ncm (2.6-l 1.3 in.lbs.)
[Spring scale reading]
5-18 N (1.140 Ibs.)
Standard value : 0.05 mm (.0020 in.) or less
f" ,:I
: I i .L
“1’:
NOTE
If adjustment is not possible, the bearing may be{’
incorrectly installed; check and, if necessary, repair. Cc.F
The lubrication condition should also be checked.
T :~~~‘~‘T
.’ _*
(3) Mount the lock washer. If the lock washer holes do not ‘L .y
align with the lock nut holes, loosen the lock nut (no
more than 30 to 40 degrees) to align them.
6. INSTALLATION OF MANUAL FREE-WHEELING HUB ASSEMBLY
Apply a coating of specified sealant, equally all around and
without any missed spots, to the free wheeling hub body
assembly and front hub contact surfaces.
Specified sealant : 3M ART Part No. 8661, No. 8663, or
equivalent
Caution
Make sure that there is no excess specified sealant on
the hub outside surface.
/ STB Revision --- -
Оригинальная страница руководства
