1987-Montero · Front susp a · страница 54 из 83 · Открыть оригинал PDF ↗
FRONT SUSPENSION - Drive shaft
9. DISCONNECTION OF TIE ROD ASSEMBLY FROM
KNUCKLE
Disconnect the tie rod from the knuckle by using the
special tool.
Cuation
1. Use cord to bind the special tool closely so it won’t
become separated.
2. The nut should Ibe loosened only, not removed.
11. DISCONNECTION OF LOWER BALL JOINT FROM
KNIUCKLE/13. UPPER BALL JOINT FROM KNUCKLE
Using the special tool, remove the lower ball joint and
upper ball joint.
Caution
1. Support the lower arm with a jack when removing
the knuckle from the lower ball joint or the upper
ball joint.
2. After the knuckle has been removed, lower the jack
slowly.
15. REMOVAL OF LEFT DRIVE SHAFT
Pull the drive shaft out from the differential carrier.
Caution
When pulling the drive shaft out from the differential
carrier, be careful Uhat the spline part of the drive shaft
does not damage the oil seal.
Проверка
NOZCXAB
l Check the boot for damage or deterioration.
l Check the ball joint for operating condition and excessive
looseness.
l Ch’eck the splines for wear or damage.
SERVICE POINTS OF INSTALLATION NOZQDAC 15. INSTALLATION OF LEFT DRIVE SHAFI-
Drive the drive shaft into the front differential carrier with a
plastic hammer.
Caution
Be careful not to damage the lip of the oil seal. Replace
the circlip which is attached to the D.O.J. side spline
part with a new one.
Оригинальная страница руководства
