1987-Montero · Front susp a · страница 83 из 83 · Открыть оригинал PDF ↗
(8)Change the side bearing adjusting spacers as illus-
trated, and then adjust the final drive gear backlash
between the drive gear and the drive pinion.
NOTE
When increasing the number of side bearing adjusting
spacers, use the same number for each, and as few as
possible.
(9)Check the drive gear and d-rive pinion for tooth contact.
If poor contact is evident, make adjustment.
(Refer to P.2-71)
(lO)Measure the drive gear runout at the shoulder on the
reverse side of the drive gear.
Limit : 0.05 mm (.0020 in.)
(1 l)lf the drive gear runout exceeds the limit, reinstall by
changing the phase of the drive gear and differential
case, and remeasure.
t
I,
31. APPLICATION OF SEALANT TO GASKET
Apply the specified sealant to both sides of the gasket and
install the differential cover to the differential carrier.
Specified sealant : 3M ART Part No. 8661 or No. 8663,
or equivalent
Оригинальная страница руководства
