1987-Montero · Front susp a · страница 28 из 83 · Открыть оригинал PDF ↗
DETERIORATION OF RETURN SPRING
Check the return spring for deterioration by following the
steps below.
(1) Measure the dimension A shown in illustration at the
opposite side of spring end.
Limit : 35 mm (1.38 in.)
Caut:ion
To measure the dimension A shown in illustration,
measure the dimension from the outermost extremity of
one wire diameter to that of the other wire diameter.
(2) If the measured value is below the limit, replace the spring.
DETERIORATION OF SHIFT SPRING
Check the shift spring for deterioration by following the steps
below.
(1) Measure the dimension 6 shown in illustration at the
opposite side of spring end.
Limi,t : 30 mm (1.18 in.)
Cau,tion
To measure the dimension B shown in illustration,
mealsure the dimension from the outermost extremity of
one wire diameter to that of the other wire diameter.
(2) If the measured value is below the limit, replace the spring.
SERVICE POINTS OF REASSEMBLY NOPJDAB
Apply the specified grease to the attaching surfaces of all
components.
Specified grease : Multipurpose grease SAE J310, NLGI
No. 2
13. AWLICATION OF GREASE TO RETAINER (B)
Pack the grooves of retainer (B) with the specified grease.
Specified grease : Multipurpose grease SAE 5310, NLGI
No. 2
12. INSTALLATION OF RETURN SPRING
Install the return spring with the smaller coil diameter side
toward the cam.
5. APIPLICATION OF GREASE TO BRAKE (B)
Pack the grooves of brake (B) with the specified grease.
Specified grease : Multipurpose grease SAE 5310, NLGI
No. 2
1 STB Revision
1
Оригинальная страница руководства
