1987-Montero · Front susp a · страница 81 из 83 · Открыть оригинал PDF ↗
24. INSTALLATION OF DRIVE GEAR
(1) Clean the drive gear attaching bolts.
(2) Remove the adhesive adhered to the threaded holes of
the drive gear by turning the tap tool (Ml0 x 1.25), and
then clean the threaded holes by applying compressed
air.
(3) Apply the specified adhesive to the threaded holes of
the drive gear.
Specified adhesive : 3M Adhesive stud locking 4170 {“*
/.’
or equivalent
(4) Install the drive gear onto the differential case with the ”
mating marks properly aligned. Be sure to tighten the “‘1;
bolts to the specified torque in a diagonal sequence. ‘,(
26. INSTALLATION OF SIDE BEARING INNER RACES
Press-fit the side bearing inner races to the differential
case by using the special tool.
E!-‘.: .i”: .I f-
ADJUSTMENT OF FINAL DRIVE GEAR BACKLASH
f :.,:
(1) Install the side bearing adjusting spacers, which areFd, ::;;
tinner than those removed, to the side bearing outer\, ;
races, and then mount the differential case assembly \,,
-3’
into the gear carrier.
. ADJUSTMENT OF FINAL DRIVE GEAR BACKLASH
:;: 2
NOTE ‘I’ ,
Select side bearing adjusting spacers with the same ‘I.
thickness for both the drive pinion side and the drive
gear side.
(2) Push the differential case assembly to one side, and
measure the clearance between the gear carrier and
the side bearing adjusting spacer with a feeler gauge.
Оригинальная страница руководства
