1987-Montero · Front susp a · страница 65 из 83 · Открыть оригинал PDF ↗
3. REMOVAL OF DUST COVER
Remove the dust cover from the inner shaft.
5. REMOVAL OF DUST SEAL
Remove the dust seal from the housing tube.
SERVICE POINTS OF REASSEMBLY 5. INSTALLATION OF DUST SEAL
NOZRHAD
(1) Press-fit the new dust seal into the housing tube by
using the special tools, until it is flush with the housing
tube end face.
(2) Apply the specified grease to the dust seal lip.
Specified grease : Multipurpose grease SAE J310,
NLGI No. 2
3. INSTALLATION OF DUST COVER
INSTALLATION OF DUST COVER ,“.
Using a steel pipe, force a new dust cover onto the inner:’
shaft. i\ ,’
| Steel pipe | mm (in.) | |
|---|---|---|
| Overall length | 50 (1.97) | |
| Outside diameter | / 75 (2.95) | |
| Wall thickness | 1 4i.16) |
Таблица в оригинале
NOTE
After the dust cover has been installed, apply specified
grease to the inside of the dust cover.
Specified grease : Multipurpose grease SAE 5310, NLGI
No. 2
2. INSTALLATION OF BEARING
Using the special tool, force the bearing onto the inner
shaft.
Оригинальная страница руководства
