1987-Montero · Front susp a · страница 32 из 83 · Открыть оригинал PDF ↗
l ADJ’USTMENT OF DRIVE SHAFT END PLAY
After assembly in the order of the shim and then the snap
ring, check the drive shaft end play.
Set the dial gauge as shown in the figure; then move the
drive shaft in the axial direction and measure the play.
Standard value : 0.2-0.5 mm (.008-.020 in.)
If the play is out of standard value, adjust by adding or
removing shims.
Оригинальная страница руководства
