1987-Montero · Front susp a · страница 51 из 83 · Открыть оригинал PDF ↗
STABILIZER BAR REMOVAL AND INSTALLATION
NOZTA-
NOTE
(I 1 Reverse the removal procedures to reinstall.
(2) l + : Refer to “Service Points of Installation”.
(3) q : Non-reusable parts.
p”’
$jfJ / ;..
INSPECTION N02T& -.“I ‘;j
l Check the stabilizer bar for deformation or damage. 6, .‘:::T. $
l Check the hanger for bends or damage. IJ; .; t. 2 .
l Check the rubber parts for cracks, deterioration or wear!. ,:,’ ‘.if
-bk ,.::
e,.. ‘&- ,.,’ -:
‘t &
SERVICE POINTS OF INSTALLATION 7. INSTALLATION OF STABILIZER BAR
When installing the hanger to the stabilizer bracket, tighten
the nut so as to obtain the specified dimension.
Standard value : 6-8 mm (.24-.31 in.)
When installing both ends of the stabilizer bar to the lower
arms, tighten the nut so as to obtain the specified
dimension.
Standard value : 6-8 mm (.24-.31 in.)
NOTE
The dimension shown in the figure is the value when a
new bushing is used.
Оригинальная страница руководства
