Pajero II Workshop Manual 1991 · FUEL · страница 62 из 339 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
SENSOR INSPECTION
(1) Disconnect the oxygen sensor connector_
Checkthatthereis continuity[approx:209at20PC
(68'F)] between oxygen sensor connector terminal 0 and
terminal @
(3) If there is no continuity, replace the oxygen sensor_
(4) Warm the engineuntilthe enginecoolant temperature
reaches 80PC (176'F) or more
(5) Use the jumper leads to connect the oxygen sensor ter-
minal 0 (connect (+) terminal) and terminal(connect
(-) terminal)to the battery (+) and (~) terminals respec-
tively
Caution
Be careful when connecting the jumper leads, as con-
nectingtheterminalsincorrectlywilldamagethe
oxygen sensor
(6) Connectdigital-type voltmetertoterminalandter-
minal @.
While repeatedly racing the engine,measure the oxygen
sensor output voltage.
Таблица в оригинале
Распознанный текст таблицы — требует сверки с оригиналом
| Engine | Oxygen sensor output voltage | Notes |
|---|---|---|
| When racing the engine | 0.6-1.0V | When the air/fuel mixture ratio is enriched by racing the engine repeatedly, normal oxygen sensor will voltage output a 0.6-1.0V. of |
NOTE
For removal and installation of the oxygen sensor,refer
to GROUP 15Exhaust Pipe, Main Muffler and Catalytic
Converter.
Оригинальная страница руководства
