Pajero II Workshop Manual 1991 · FUEL · страница 202 из 339 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
Распознанный текст таблицы — требует сверки с оригиналом
| Output preference | Diagnosis item | Diag | nosis code | Check item (Remedy) |
|---|---|---|---|---|
| order | No | Memory | ||
| Engine coolant temperature sensor | 21 | Retained | Harness and connector Engine coolant temperature sensor | |
| Crank angle sensor | 22 | Retained | Harness and connector (If harness and connector are normal, replace distributor assembly ) | |
| Top dead center cylinder) sensor (No. | 23 | Retained | Harness and connector (If harness and connector are normal, replace distributor assembly ) | |
| Vehicle speed sensor (reed switch) | 24 | Retained | Harness and connector Vehicle speed sensor (reed switch) | |
| 10 | Barometric pressure sensor | 25 | Retained | Harness and connector (If harness and connector are normal, replace barometric pressure sensor assembly ) |
| Ignition timing adjustment signal | 36 | Harness and connector | ||
| 12 | Injector | 41 | Retained | Harness and connector Injector coil resistance |
| 13 | Fuel pump | 42 | Retained | Harness and connector Control relay |
| 14 | Servo valve position sensor | 55 | Retained | Harness and connector ISC servo (lf harness and connector are normal, replace ISC servo assembly. |
| 15 | Normal state |
NOTE
Replace the engine control unit if a malfunction code is output although the inspection reveals that there
is no problem with the check items
READ OUT OF MALFUNCTION CODE
Refer to P.13-11 .

