Pajero II Workshop Manual 1991 · FUEL · страница 304 из 339 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
NOTE
Auto-cruise control system cannot be set.This chart is to be used, then, for troubleshooting if it is not
possible to use the self-diagnosis for checking
Таблица в оригинале
Распознанный текст таблицы — требует сверки с оригиналом
| Prepare to conduct input checkin: (P13-187) | ||||
|---|---|---|---|---|
| Are th | g . e results of all input checks normals? | |||
| Yes | No | |||
| Check results | Probable cause | Remedy | Check chart No | |
| Code 21 remains even though SET switch is set to OFF. | SET switch ON malfunction | Replace the control switch: | No. | |
| line SET switch input short-circuit | Repair the harness | |||
| Code 22 remains even though RESUME switch is set to OFF | RESUME switch ON malfunction | Replace the control switch. | No. | |
| RESUME switch input line short-circuit | Repair the harness. | |||
| Code 23 remains even if the stop lamp switch is turned OFF by releasing the brake pedal: | Malfunction of stop lamp switch circuit: | Replace stop lamp switch or repair harness | No. | |
| Code 25 remains, and code 24 does not appear, even though vehicle speed reaches approximately 40 km/h (25 mph) or higher. | Malfunction of the vehicle-speed sensor circuit (damaged or disconnected wiring, short-circuit} | Check or repair the vehicle speed sensor circuit | No. | |
| Code 26 remains even if the clutch switch is turned OFF by releasing the clutch pedal. <M> | Malfunction of clutch switch circuit. | Replace clutch switch or repair harness_ | No. | |
| Code 26 remains even if the selector lever is moved to anything but N, <AT> | Malfunction of inhibitor switch circuit. | Replace inhibitor switch harness repair | No. | |
| Code 27 remains even though CANCEL switch is set to OFF. | Malfunction of CANCEL switch circuit, | Replace the control switch or repair harness | No. | |
| Code 28 remains even if the accelerator is released. <3000> | Malfunction of throttle position sensor circuit: | Replace the sensor repair harness. | No. 11 | |
| Code 29 remains even though the idle switch is set to ON <3000> | Malfunction of idle switch circuit | Replace the switch Or repair harness_ | No. 11 |
Check the motor-driven vacuum pump
circuit. (Go to check chart No_6)
NOTE
If the results of the check of the motor-driven vacuum pump cir-
cuit (check chart No. 6) and actuatorreveal no abnormal condi-
tion, replace the electronic control unit (ECU):
Оригинальная страница руководства
