Очистка дроссельного узла и заслонки · 102 — Pajero II 1991–1998 — руководство по ремонту

Очистка дроссельного узла и заслонки · 102

THROTTLE BODY (THROTTLE VALVE AREA) CLEANING · 102

Pajero II Workshop Manual 1991 · FUEL · страница 102 из 339 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

SERVICE ADJUSTMENT PROCEDURES

ACCELERATOR CABLE INSPECTIONANDAD-
JUSTMENTVEHICLESWITHOUTAUTO-
CRUISE CONTROL SYSTEM>E13FCAZ3
Refer to P.13-14,
For models equippedwith the auto-cruise control system
refer to P.13-188

FUEL FILTER REPLACEMENTE13FZAM
Refer to P.13-14
FUEL GAUGE UNIT REPLACEMENTE13FDAD
Refer to P.13-15.
2-WAY VALVE REPLACEMENTE13FFAD
Refer to P.13-15.
FUEL PUMP OPERATION CHECKE13FGCF
Refer to P.13-15.
HOw To REDUCE THE FUEL LINE INTERNAL
PRESSUREE13HABH
Refer to P.13-16.

Очистка дроссельного узла и заслонки

(1)Start the engine and warm it up until the temperature of
the engine coolant reaches 80*C (176*F) or higher; then
stop the engine.

Disconnect the air intake hose at the throttle body side_
Plug the bypass intake port inlet in the throttle body_

Caution

Never let cleaning liquid getinto the bypass intake

Spraycleaning liquid (from the intake port of the throttle
body) onto the valve, and then leave as is for about five
minutes

Start the engine and race it a few times; then let it run at
idle speed for about one minute.

NOTE

Theengineidling speedbecomesunstable(orthe
engine stalls) if the by-pass passage is plugged,(or the
engine stalls),let the engine run with the throttle valve
slightly open_

Оригинальная страница руководства
Страница 102
100%

Назад
Сверху