Pajero II Workshop Manual 1991 · FUEL · страница 103 из 339 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

(6) If depositsarenotremovedfromthethrottlevalve
repeat steps (4) and (5) .
Remove the plug from the bypass intake port inlet in the
throttle body.

(8) Connect the air intake hose_

(9) UsingtheMUT-IL,erasetheself-diagnosiscodeordis-
connectthenegativebatterycableformorethan10
seconds and then connect it again.

(10J Adjust the basic idle speed. (Refer to P13-79-24)
NOTE

hunting of theidlingengine occurs after adjusting the
basicidlingspeed,remove the battery (~ ) cablefromthe
battery terminal for more than 10 seconds, and then idle the
engine again:

IDLE POSITION SWITCH AND THROTTLE POSI TION SENSOR ADJUSTMENT

(1)Disconnect the connector of the throttle-position sensor_

(2) Using jumper wires, connect an ohmmeter across terminal
(idle position switch) and terminal 0 (sensor earth) of the
throttle position sensor

Insert0.65mm (0.0256 in.) thick thickness gauge
between the fixed SAS and throttle lever.

REVISED

Оригинальная страница руководства