Pajero II Workshop Manual 1991 · FUEL · страница 334 из 339 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

InhibitorSwitch("N"position)Inspection <AIT>

<Vehicles built up to October, 1993>

(1)Disconnect the connector

(2)Check tobe sure that there is continuity between con-
nector terminalsand (12)when the selector lever is
moved to theN" range.

<Vehicles built from November, 1993>

Disconnect the connector

Checktobesurethat thereis continuitybetween
connector terminals (5) and (61 when the selector lever is
moved to theN
range.

Throttle Position Sensor Inspection <3000, 3500>
Refer to P.13-17

Idle Switch Inspection <3000, 3500>
Refer to P.13-17.

Vehicle-speed Sensor Inspection

Refer to GROUP 54Meters and Gauges

Auto-cruise Vacuum Pump Inspection

<Solenoid valve (Control valve, Release valvel>

1)Remove the auto-cruise vacuum pump connector.
Measure theresistance valuebetweenterminals (1)-(2)
and between (1)-(3)

Standard value:50-60 92

(3)Check that the solenoid valve makes an operating noise
when battery voltageisimpressedbetweenterminals
(1)-(2) and between (1)-(3).

(4) If there isa malfunctionofthesolenoid valve , replace
the auto-cruise vacuum pump assembly.

<Motorz

(1) Remove the auto-cruise vacuum pump connector
21 Check thatthemotor revolveswhen battery voltage is
impressed between terminals (1)-(4).

Actuator Inspection

Remove the actuator.

2) Apply negative pressure to the actuator with the vacuum
pumpandcheckthattheholdermovesmorethan
35mm(1.38in.).In addition,checkthatthereisno
change in the position of the holder when negative pres-
sure is maintained in that condition_

(3) First install the actuator ad then inspect and adjust the
auto-cruise control cable.(Refer to P.13-188.)

Оригинальная страница руководства