Pajero II Workshop Manual 1991 · FUEL · страница 105 из 339 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

(4) Tighten the fixed SAS slowly to findpoint at which it
contacts the throttle lever (where the throttle valve starts
opening). From that point,tighten the fixed SAS further
'Ia turns_

(5) Holding the fixed SAS to prevent it from turning, tighten
the lock nut securely

(61Adjust the accelerator cable tension:(Refer to P.13-79-
21)

Adjust the basic idle speed.

Adjust the idle position switch and throttle position sensor
(TPS) . (Refer to P13-79-22)

BASIC IDLE SPEED ADJUSTMENT

NOTE

The basic idle speed has been factory-adjusted with the
speed adjusting screw (SAS) addoesnot normally re-
quire adjustment:

2If the adjustment is required,first check that the ignition
plug, injector, ISCservo, and compressionpressure are
normal,

1) Before starting the inspection and adjustment procedures,
set the vehicle in the following conditions:
Engine coolant temperature:80to95*€(176to
205*F)

Lamps, accessories: OFF
Transmission:Neutral (P for vehicles withan automatic
transmission)

(2)If the MUT-II is used, connect it to the diagnosis connector.
NOTE
WhentheMUT-IIconnected,the diagnosticcontrol
terminal is earthed.

(3)If the MUT-II is not used, follow the steps below.
Insert a paper clip into the 1-pin connector shown in the
figure at the left:

Connect a primary-voltage-detection type of tachometer
to the paper clip:

Use the special tool (diagnosis code check harness) to
earth the diagnosis test mode control terminal (terminal
(I)) of the diagnosis control terminal (16 pin):

PWJE9086-F

Оригинальная страница руководства