Pajero II Workshop Manual 1991 · FUEL · страница 163 из 339 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

SENSOR INSPECTION

(1)Disconnect the oxygen sensor connector.
Checkthat there is continuity (approx:20 9 at 20*C
(68PFV] between oxygen sensor connector terminal
and terminal

(3) If there is no continuity, replace the oxygen sensor.

(4)Warm the engine until the engine coolant temperature
reaches 80*C (1768F) or more

(5) Use the jumper leads to connect the oxygen sensor ter-
minal(connect (+) terminal)and terminal(connect
(-) terminal) tothe battery (+) and (-) terminals respec-
tively.

Caution

Be careful when connecting the jumper leads, as con-
nectingtheterminalsincorrectlywilldamagethe
oxygen sensor.

(6) Connectdigital-type voltmeterto terminaland ter-
minal

While repeatedly racing the engine, measure the oxygen
sensor output voltage

Таблица в оригинале

Распознанный текст таблицы — требует сверки с оригиналом

Engine	Oxygen sensor output voltage	Notes
When racing the engine	0.6-1.0V	When the air/fuel mixture ratio is enriched by racing the engine repeatedly, normal oxygen sensor will output a voltage of 0.6-1.0V.

NOTE

For removal and installation of the oxygen sensor,refer
to GROUP 15ExhaustPipe ,Main Muffler and Catalytic
Converter.

Оригинальная страница руководства