Pajero II Workshop Manual 1991 · FUEL · страница 332 из 339 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

Service Adjustment Procedures

AUTO-CRUISE CONTROL SWITCH INSPECTION Auto-cruise Control Setting Check

(1) Switch ON the main switch.

(2)Drivveatthedesiredspeedwithintherangeofap-
proximately 40-200 km/h (25_125 mph).

(3)Turn the control switch to the SET position.

(4) Check to be sure that when theswitch is released the
speed is the desired constant speed_

NOTE

If the vehicle speed decreases to approximately 15 km/h
(9 mph) below the set speed, because of climbing a hill
for example, the auto-cruise control will be cancelled.

Speed-increase Setting Check

Set to the desired speed.

Turn the control switch to RESUME position:
Check tobesure that accelerationcontinueswhilethe
switch is hold, and that when it is released the constant
speedat thetimewhenwasreleasedbecomes the
driving speed:

NOTE

Even if, during acceleration, the vehicle speed reaches or
exceedsthehighlimit[approximately200km/h
(125mph)l;accelerationwill continue, however,when
theswitchisreleased,thesetspeed("memorized
speed") will become the high limit of the vehicle speed

Speed Reduction Setting Check

1) Set to the desired speed.
(2)Turn the control switch to the SET position.

(3)Check tobesurethat decelerationcontinues while the
switch is pressed,and that when it is released the con-
stant speed at the timewhen it was released becomes
the driving speed:

NOTE

Whenthevehiclespeedreachesthelowlimit[ap
proximately 40km/h(25 mph)] during deceleration, the
automatic speed controlwillbe cancelled_

Auto-cruiseControlCancellationCheckand Check of Return to the Set Speed before Can- cellation

Set the auto-cruise speed control.

(2) Check to be sure that there is a return to ordinary driving
when either of the operations below is performed.

Оригинальная страница руководства