Pajero II Workshop Manual 1991 · FUEL · страница 104 из 339 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
(4)Loosen the throttle position sensor mounting bolts ad
turn the throttle position sensor body fully clockwise.
(5)In this condition, check that there is continuity across ter-
minalsand
(6) Slowly turn the throttle position sensor counterclockwise
untilyou findpointatwhichthereisno continuity
acrossterminalsand0Then,tightenthethrottle
position sensor mounting bolt securely
Connect the throttle position sensor connector.
(8) If the MUT-II is used, connect it to the diagnosis connector
(9)If a MUT-II is not used, perform the following operation.
Disconnectthethrottle positionsensor'sconnector
and make connections between the two disconnceted
connector valvesusingthe special tool (test harness
set):
Connect a digital voltmeter between terminal 0 (sensor
output) and terminal(sensorearth) of the throttle
positionsensor.
(1O)SwitchON the ignition switch:
(Do not start the engine:)
(11) Check theoutput voltageof thethrottle-position sensor.
Note,if the MUT-II isused,that itemNo.14 shouldbe
selected to get the read-out of the throttle-position sensor's
output voltage.
Standard value400-1,000 mv
(12)lf the voltage is out of specification, check the throttle
position sensorand associatedharnesses
13)Remove the feeler gauge
14)Turn the ignitionswitch OFF.
FIXED SAS ADJUSTMENT
NOTE
The fixed SAS has been factory-adjusted:Never attempt
to move it.
2.Should it be out of proper adjustment, adjust by follow-
ing the procedure given below.
(1) Sufficiently slacken the accelerator cable.
21Loosen the lock nut on the fixed SAS
(3) SufficientlyloosenthefixedSASbyturning
counterclockwise tofullyclose the throttle valve
REVISED
PWJE9086-F
Оригинальная страница руководства
