MANUALS · FUEL [13] · страница 41 из 340 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
Проверка
Using Multi-use tester (MUT)
Таблица в оригинале
Распознанный текст таблицы — требует сверки с оригиналом
| Function | Item No. Data display | Check conditions | Engine coolant temperature | Stand "C (PF) | ard value |
|---|---|---|---|---|---|
| Data reading | I Sensor 21 detection temerature | gnition switch: ON Or, engine unning | When -20 (-4) When 0 (32) | -20 | |
| p | When 20 (68) | 20 | |||
| When 40 (104) | 40 | ||||
| ARNESS IN | SPECTION | When 80 (176) | 80 | ||
| Harne conect | ss side or 7FUO668 | Check for con earth: circuit. Connector: | tinuity of the Disconnected | (OK) | 2 Repair harne 0 0 |
HARNESS INSPECTION
SENSOR: INSPECTION
(1)Remove engine coolant temperature sensor from the intake
manifold:
(2)Withtemperature sensing portionof coolant temperature
sensor immersed in hot water check resistance_
Таблица в оригинале
Распознанный текст таблицы — требует сверки с оригиналом
| Temperature | (PF) | Resistance | kS2 |
|---|---|---|---|
| 0 (32) | 5.8 | ||
| 20 (68) | 2.4 | ||
| 40 (104) | |||
| 80 (176) | 0.3 |
(3)If the resistance deviates from the standard value greatly,
replace the sensor
INSTALLATION
(1) Apply specified sealant to threaded portion.
Specified sealant:3M Nut locking No. 4171Or
equivalent
(2) Install engine coolant temperature sensorandtighten it to
specified torque.
Sensor tightening torque:30 Nm (3.0 kgm, 22 ft Ibs)
(3)Fasten harness connectors securely.
PWJE9086
Оригинальная страница руководства
