MANUALS · FUEL [13] · страница 137 из 340 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
SENSOR INSPECTION
(1) Disconnect the throttle position sensor connector.
(2) Measure resistance between terminal(sensor earth) and
terminal(sensor power):
Standard value:3.5-6.5 ko
(3) Connectpointertypeohmmeterbetweenterminal
(sensor earth) and terminal @ (sensor output)
(4) Operate the throttle valve slowlyfromthe idle position to the
full open positionand check that the resistance changes
smoothly in proportion with the throttle valve opening angle
(5) If the resistance is out of specification, or fails to change
smoothly. replace the throttle position sensor.
TPS installation torque:2.0 Nm (0.2 kgm, 1.5 ft.Ibs)
For the idle position switch and throttle position sensor ad-
justing procedure, refer to P13-79-22.
Оригинальная страница руководства
