MANUALS · FUEL [13] · страница 279 из 340 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

SERVICE POINTS OF REMOVAL

8.REMOVAL OF INJECTION PIPE

Loosen the nuts at the end of the injection pipe with the
corresponding holders (delivery holder for pump side and
nozzle holder for nozzle side) retained by a spanner, etc_

9.REMOVAL OF FUEL INJECTION PUMP

Align the notch of the crankshaft pulley with the "0" timing
mark to set the No,cvlinder to the compression top dead
centreposition.

NOTE

If the protrusion on the camshaft is pointing directly upwards
when the filler cap is removed, the No.cylinder will be at
the compression top dead centre position.

SERVICE POINTS OF INSTALLATION

9_INSTALLATION OF INJECTION PUMP

Check that the Nocylinder is at the compression top
deadcentre positionand aligningthenotchofthe
injection pump gear with theTmatingmark onthe
flange plate,and then install the injection pump to the
timing gear case_

Mitsubishi Motors Corporation

8.INSTALLATION OF INJECTION PIPE

Tighten thenutsat theendof the injection pipe tothe
specified valuewiththe correspondingholders (delivery
holder forpumpsideandnozzle holder for nozzle side)
retained by a spanner, etc_

Оригинальная страница руководства