MANUALS · FUEL [13] · страница 170 из 340 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
Проверка
Using MUT-II
Таблица в оригинале
Распознанный текст таблицы — требует сверки с оригиналом
| Function | Item No | Data display | Check condition | Load state | Standard value |
|---|---|---|---|---|---|
| Data reading | 45 | Stepper mo- tor steps | Engine coolant tem- perature: 80-95*C (176-2059F) | Air conditioner switch: OFF | 2-25 steps |
| Lamps, acces- units: All S Transmission: Neu- tral Idle position switch: ON (com- pressor clutch to be ON if air condi- tioner switch is ON) Engine: Idling | Air conditioner switch: ON | Increase by 10-70 steps |
NOTE
When the vehicle is new Iwithin initial operation of about 500 km (300 miles)l; the stepper motor steps may be
about 30 steps more than standard.
Wave Pattern Inspection Using an Analyzer Measurement method
(1) Disconnect the stepper motor connector; and connect the
special tool (test harness: MB998463) in between.
(2) Connect the analyzer special patterns pickup to the stepper
motor-side connector terminal 0 (red clip on the special tool) ,
terminal(blue clip) , terminal @ (black clip) and terminal
(yellow clip) respectively:
Standard wave pattern
Observation conditions
Таблица в оригинале
Распознанный текст таблицы — требует сверки с оригиналом
| Function | Special patterns |
|---|---|
| Pattern height | High |
| Pattern selector | Display |
| Engine condition | Turn the ignition switch from OFF to ON (without starting the engine). |
| idling, While the engine is turn the air conditioner switch to ON_ | |
| Immediately after starting the warm engine (approx minute)_ |
Оригинальная страница руководства
