MANUALS · FUEL [13] · страница 229 из 340 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

HARNESS INSPECTION

(1)Disconnect the throttle position sensor connector,
(2)Measure . resistancebetweenterminal(sensor earth)
and terminal(sensor power) .
Standard value:3.5-6.5 kQ

(4) Operate the throttle, valve slowly fromthe idle position
tothe full open positionandcheck that the resistance
changes smoothly in proportionwiththethrottle valve
opening angle_

(5) If the resistance is out of specification, or fails to change
smoothly, replace the throttle position sensor.
TPS installation torque:2.0 Nm (0.2 kgm, 1.5 ft.lbs )

Оригинальная страница руководства