MANUALS · FUEL [13] · страница 67 из 340 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

Checking the Injection Condition

(1) Following the steps below, bleed out the residual pres-
sure within the fuel pipe line to prevent flow of the fuel.
(Refer to P13-16,)

(2)Remove the injector

Arrange the special tool (injector test set), adaptor, fuel
pressure regulator and clips as shown in the illustration
below

Connect the battery's negativeterminal
Apply battery voltagetothe fuel pump check terminal
and activate the fuel pump_

(6)Activate the injector and check the atomized spray condi-
tion of the fuel:The condition can be considered satisfac
tory unless it is extremely poor.

Stop the actuation of the injector, and check for leakage
from the injector's nozzle_

Standard value:1 dropOrless per minute

fuel
(8) Activate the injectorwithout activatingthepump;
then, when the spray emission of fuel from the injector
stops:disconnectthe special tooland restoreit to its
original condition:

Mitsubishi Motors Corporation

Feb. 1991

Оригинальная страница руководства