MANUALS · FUEL [13] · страница 208 из 340 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

(8) Connect the multi use tester (MUT) to the diagnosis con-
nector.

(9) Turn the ignition switch ON (but do not start the engine):

(1OJUsing the MUT, select item No.14 and read the throttle
position sensor output voltage

Standard value:400-1,000 mV

(11)lf the voltage is out of specification, check the throttle
position sensor and associated harnesses.

(12)Remove the feeler gauge_

(13)Turn the ignition switch OFF.

FIXED SAS ADJUSTMENTE13HAMCZ

NOTE

The fixed SAS has been factory-adjusted.Never attempt
to move it

2.Should it be out of proper adjustment, adjust by follow-
ing the procedure given below:

(1) Sufficiently slacken the accelerator cable_

(2) Loosen the lock nut on the fixed SAS

(3) SufficientlyloosenthefixedSASbyturningit
counterclockwise to fully close the throttle valve:
(4) Tighten the fixed SAS slowly to findpoint at which it
contacts the throttle lever (where the throttle valve starts
opening)Fromthat point, tighten the fixed SAS further
1/4 turns

(5) Holding the fixed SAS to prevent it from turning, tighten
the lock nut securely.

(6) Adjust the accelerator cable tension.(Refer to P.13-89.)
Adjust the basic idle speed:(Refer to P.13-93.)

8) Adjust the idle position switch and throttle position sen-
sor (TPS) (Refer to P.13-91.)

Оригинальная страница руководства