MANUALS · FUEL [13] · страница 259 из 340 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

SERVICE ADJUSTMENT PROCEDURES
FUEL INJECTION TIMING INSPECTION AND AD-
JUSTMENTE13FKAD

Refer to GROUP 11Service Adjustment Procedures

ENGINE IDLING SPEED INSPECTIONANDAD-
JUSTMENTE13HBAA

Refer to GROUP 11

Service Adjustment Procedures:

ACCELERATORCABLEINSPECTIONANDAD-
JUSTMENT<VEHICLESWITHOUTAUTO-
CRUISE CONTROL SYSTEM>E13FCAZ3

Formodels equippedwiththe auto-cruise control system,
refer to P.13-188

(1) Turn the air conditioner and all lights OFF so that there is
no electrical load when inspecting:

(2) Warm the engine until the engineidlingspeed becomes
stable.
(3) Check that the engineidlingspeed isat the specified

(3) Check that the engine
value

(4) Stop the engine ad turn the ignition switch to OFF
(5) Check that there areno sharp bends in the accelerator
cable_

6) Check the amount of play in the inner cable.
If there is excessive play in the inner cable, or if there is
noplay, adjust by the following procedure
Loosen the adjusting nut andfullyclose the throttle
lever

Tighten the adjusting nut so that the inner cable play
is at the standard value, and fix it withthe lock nut.

Standard value:0-1mm (0-0.04 in.)

After adjusting, check that the throttle lever is touch-
ing the idle adjusting screw (stopper)_

FUEL FILTeR REPLACEMENTE13FZAN
(1) Removetheintercooler.(RefertoGROUP15Inter-
cooler:)

(2)Remove the fuel tank cap to release the pressure inside
the tank:

(3) Disconnect the water level sensor connector.

(4) Remove the fuel hose and then remove the fuel filter.
Caution

Cover withrag to prevent fuel from spraying out:

PWJE9086

Оригинальная страница руководства