MANUALS · FUEL [13] · страница 175 из 340 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
Проверка
Using MUT-II
<Spark Advancez
Таблица в оригинале
Распознанный текст таблицы — требует сверки с оригиналом
| Function | Item No. | Data display | Check condition | Engine state | Standard value |
|---|---|---|---|---|---|
| Data reading | 44 | Ignition advance | Engine: Warming up Timing lamp: Set (set timing lamp to check actual igni- tion timing) | 700 r/min (Idle) 2,500 rlmin | 7-230 BTDC 27-470 BTDC |
<lgnition Timing Adjustment Mode>
Таблица в оригинале
Распознанный текст таблицы — требует сверки с оригиналом
| Function | Item No | Data display | Check condition | Terminal condition | Standard value |
|---|---|---|---|---|---|
| Data list | 36 | Continuity present or not present between ignition timing adjust- il d | Engine: Idling | timing Ignition ad- justment terminal is earthed | ON |
| ment termna an earth | timing Ignition ad- justment terminal is disconnected from earth | OFF |
<Standard Ignition Timing>
Таблица в оригинале
Распознанный текст таблицы — требует сверки с оригиналом
| Function | Item No_ | Drive | Check condition | Normal condition |
|---|---|---|---|---|
| Actuator test | 17 | Set to ignition timing ad- justment mode | Engine: idling Timing lamp: set | 58 BTDC + 30 |
Wave Pattern Inspection Using an Analyzer
Ignition coil primary signal
Refer to GROUP 16Ignition System:
Power transistor control signal.
<Measurement method>
(1) Disconnect the power transistor connector, and connect the
special tool (test harness: MB991348) in between: (All termi-
nals should be connected:)
(2) Connect the analyzer special patterns pickup to the con-
nector terminals 0 (No.3-No.6),(No:2-No.5) and
(No.1-No4} in that order.
Оригинальная страница руководства
