MANUALS · FUEL [13] · страница 163 из 340 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

SENSOR INSPECTION

(1) Disconnect the oxygen sensor connector.
Check that there is continuity [approx:20 9at 20*C
(68PF)] between oxygen sensor connector terminal
and terminal

(3) If there is no continuity, replace the oxygen sensor.

Warm the engine until the engine coolant temperature
reaches 80PC (176'F) or more

(5) Use the jumper leads to connect the oxygen sensor ter-
minal(connect (+) terminal)and terminal(connect
(-) terminal) to the battery (+) and(-) terminals respec
tively.

Caution

Be careful when connecting the jumper leads, as con-
nectingtheterminalsincorrectlywilldamagethe
oxygen sensor.

(6) Connectdigital-type voltmeter to terminalandter-
minal

While repeatedly racing the engine, measure the oxygen
sensor output voltage.

Таблица в оригинале

Распознанный текст таблицы — требует сверки с оригиналом

Engine	Oxygen sensor output voltage	Notes
When racing the engine	0.6-1.0V	When the air/fuel mixture ratio is enriched by racing the engine repeatedly, normal oxygen sensor will output a voltage of 0.6-1.0V

NOTE

For removal and installation of the oxygen sensor, refer
to GROUP 15Exhaust Pipe, Main Muffler and Catalytic
Converter.

Оригинальная страница руководства