MANUALS · FUEL [13] · страница 104 из 340 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
(4) Loosen the throttle positionsensor mountingboltsand
turn the throttle position sensor body fully clockwise.
(5) In this condition, check that there is continuity across ter-
minalsand
7FU0461
(6) Slowly turn the throttle position sensor counterclockwise
untilyoufindpoint" at whichthereisno continuity
acrossterminalsand @Then,tightenthethrottle
position sensor mounting bolt securely.
Connect the throttle position sensor connector.
(8)If the MUT-II is used, connect it tothediagnosis connector
(9) If a MUT-II is not used, perform the following operation:
Disconnect the throttle positionsensor'sconnector
and make connections between the two disconnceted
connector valves using the special tool (test harness
set):
Connect a digital voltmeter between terminal @ (sensor
output) and terminal(sensor earth) of the throttle
position sensor.
(1OSwitchON the ignition switch
(Do not start the engine:)
(11) Check theoutputvoltage of the throttle-positionsensor
Note, if the MUT-II is used,that itemNo14 shouldbe
selected to get the read-out of the throttle-position sensor' s
output voltage.
Standard value400-1,000 mV
(12)lf the voltage is out of specification, check the throttle
position sensor and associated harnesses_
13)Remove the feeler gauge
4)Turnthe ignition switch OFF.
FIXED SAS ADJUSTMENT
NOTE
The fixed SAS has been factory-adjusted.Never attempt
to move it
Should it be out of proper adjustment, adjust by follow-
ing the procedure given below
(1) Sufficiently slacken the accelerator cable_
(2) Loosen the lock nut on the fixed SAS.
(3) SufficientlyloosenthefixedSASbyturning
counterclockwise to fully close the throttle valve.
@ Mitsubishi Motors CorporationJun: 1994
Оригинальная страница руководства
